John Valve's factory was permitted and approved by TUV Rheinland / Berlin-Brandenburg to affix the following CE markding to the pressure equipment (industrial valves) described and manufactured by John Valve.

John Valve is approved according to Directive 97/23/EC to have the QA System of Module D1.

Products with CE Marking

Currently, John Valve's products that has CE Marking are of the followings:

	JV-1		JV-9301N-ST
	JV-1B		JV-9302N
	JV-1H		JV-2FB
	JV-2B		JV-2FH
	JV-9301N		JV-2FC
	JV-9301NC		JV-9301NF

Definition of CE Marking

1. The CE marking consists of the initials 'CE' in accordance with the model in Annex Vl. The CE marking shall be accompanied by the identification number, as referred to in Article 12 (1), of the notified body involved at the production control phase.

2. The CE marking shall be affixed in a visible, easily legible and indelible fashion to each - item of pressure equipment referred to in Article 3 (1), or - assembly referred to in Article 3 (2) which is complete or is in a state permitting final assessment as described in section 3.2 of Annex I.

3. It is not necessary for the CE marking to be affixed to each individual item of pressure equipment making up an assembly as referred to in Article 3 (2). Individual items of pressure equipment already bearing the CE marking when incorporated into the assembly shall continue to bear that marking.

4. Where the pressure equipment or assembly is subject to other Directives covering other aspects which provide for the affixing of the CE marking, the latter shall indicate that the pressure equipment or assembly in question is also presumed to conform to the provisions of those other Directives. However, should one or more of those Directives allow the manufacturer, during a transitional period, to choose which arrangements to apply, the CE marking shall indicate conformity only with the Directives applied by the manufacturer. In this case, the particulars of the said Directives, as published in the Official Journal of the European Communities, must be given in the documents, notices or instructions required by the Directives and accompanying the pressure equipment or assembly.

5. The affixing of markings on pressure equipment or assemblies which are likely to mislead third parties as to the meaning or form of the CE marking shall be prohibited. Any other marking may be affixed to pressure equipment or assemblies provided that the visibility and legibility of the CE marking is not thereby reduced.